First, clean up the dirt, broken straw, grain and other debris inside and outside the harvester, rinse it with water, dry it and put it into the hangar for storage.
The second is to remove all the triangle drive belts, wipe them clean, apply talcum powder, put them in plastic bags, and hang them on the walls inside the warehouse; remove the drive chain and put them into diesel oil, clean them, apply oil or butter, use Wrap in plastic paper and store in a well-ventilated and dry place.
The third is to thoroughly inspect the wear parts on the harvester. Such as moving blades and fixed blades on the header, auger telescopic rod sets, roller nails and so on. If it is found to be excessively worn, deformed or damaged, it should be repaired or replaced.
The fourth is to add grease to the rotating bearings on the various components. For friction parts, such as cutters, clutch jaws, auger telescopic rods, adjusting bolts, etc., apply oil or butter to prevent corrosion, the paint has been worn away or Rusted exposed parts, repainted after rust removal.
The fifth is to use the square wood to lift the harvester off the ground, lower the header and reel to the low position of Zui, and place it on the skid smoothly, so that the lifting handle of the hydraulic lifting system is lowered.
The sixth is to remove the battery and store it separately. There are two ways to save: 1 charge water injection method. After the battery is fully charged, pour out the electrolyte, exchange distilled water, park for 6 hours, recharge for 4 hours, replace the distilled water and then charge for 2 hours, then pour off the distilled water, then fill it with new distilled water, which can be stored for a long time. Pay attention to the insulation and antifreeze. 2 dry storage method. Discharge the battery completely, pour out the electrolyte and rinse with distilled water several times until the water is not acidic. Rinse the distilled water, dry it, tighten the hole cover, seal the vent hole, and store it for a long time.
The seventh is to remove the main electrical components such as generators and lighting headlights, wipe them clean, and store them separately to prevent damage.
Eight is to open the engine water tank, the body, and other water discharge switches, to release clean water; discharge the fuel in the fuel tank; wrap the air filter, exhaust pipe port, fuel tank filler port and other parts with plastic cloth; inject into the cylinder Clean the oil and turn the crankshaft a few times.
Nine is to shake the engine crankshaft twice a month by hand, and inject a small amount of cleaning oil into the cylinder; pull the hydraulic lifting handle 10 to 20 times.
